MCSE习题——基础知识（6）
添加时间: 2007-4-8 2:43:49 作者: 微软认证参考 阅读次数:36 来源: http://www.d9soft.com
76.
You want to install a 100MBPS backbone ethernet network that connect 5 networks.which media?
a.cata 5 UTP
b.CATA 3 UTP
c.RGB-58 A/U
d.fiber-opticcable
ans:d
77.
You want to connect 2 computors by 10base-T ethernet .they are located more than 300 meters apart.Which device should you use
a.repeater
b.amplifier
c.multiplexer
d.gateway
ans:a
78.which network device is used to translate protocol?
a.repeater
b.router
c.bridge
d.gateway
ans:d
79.you are designing a peer-to-peer network that consists of 5 microsoft windows 95 computers. Which protocol should you use?
a.DLC
b.NFS
c.nwlink ipx
d.XNS
ans:c
80.you are desighing a 100 Mbps network ,which media?
a.RG-59 A/U COAXIAL
B.SPREAD SPECTRUM
C.CATAGORY 5 UTP
D.TYPE 1 STP
ans:c
81.your 10baseT network use netbeui.users of you client computer want to acccess to IBM 3090 mainframe computor by using a program
Which device should you use?
a.router
b.hub
c.brouter
d.gateway
ans:d
82.you want to connect you Ethernet and Tokenring network.both network run nwlink.Which device?
a.router
b.hub
c.brouter
d.gateway
ans:ac
83.Which Wan connection service can provide transportspeed more than 100Mbps?
a.ATM
b.ISDN basic channel
c.X.25
d.T1
ans:a
85.client computers on you Ethernetwork are not able to access the server. You use a Volt-ohmerter to measure the resistance between the center core and the shield on the cable.on T-connecters,and the temminitor. you obtain the following data:
RGB58-A/U COAXIAL CABLE :(ohms)
0
BOTH T-CONNECTERS(ohms) :
BOTH TERMINATORS:(ohms)
50
What must you do to repair the network?
a.replace the 50 ohms terminator with 25 ohm termenator
b.replace the 50 ohmsterminator with 100 ohm termenator
c.install replacement T-connector
d.install replacement RGB58-A/U CABLE
ans:d
86.YOUR network has 35 client computor and one server.The server runs WINDOWS NT SERVER.The network performance is steadlu decreasing as new clientscomputers are adding to the network .you runs the performance monitor,and obtain the following stastics:
COUNTOR AVERAGE
%processor time8
page faults/sec2
%disktime25
What should you do to improve the network perfomance?
a.replace the server with a multiprocessor computer
b.install additional RAM in the server
c.install disk strippiing with parity on the server
d.segment the network by adding another adapter on the server
ans:d
87.In the past year ,you have added 55 client computors to you 10BaseT Ethernet network.users on the jnetwork reports that network response is slow during peak hours of usage.
Which solution es the most economical?
a .replace with FDDI
b.replace with ethernet switchs:low costs:
c.replace with 100Mbps ATM
d.replace with 10-Mbps token-ring
ans:b
88.Current network configratiohn:
SERVER27,RUN WINDOWS NT SERVER
CLIENTS750
PROTOCOLS NETBEUI ,NWLINK.TCP/IP
You add a new client computer to the network,which use nwlink ipx,you are not able to access to some of the shared network resources from the new computer.All of the other computer on the network are able to connect to all the resource.
What is the most likely cause of the problem?
a.the subnet mask setting on the new client computer,
b.there is a protocol mismatch between the new client computer with some of the server.
c.the netbios name of the new client computer is the same with the server it cannot connect to.
ans:b
89.you are the administrator of a 20 computer Ethernet network.Sometimes 1 or 2 computors are not able to access network resources. the problems have been occured on every computer randomly times.Some of the cable is RGB58 /U SOLID CORE COAXIAL CABLES, and some are RGB58 A/U STRANDED CORE COAXIAL CABLES.You use a Volt-ohmerter to measure the resistance between the center core and the shield on the cable.on T-connecters,and the temminitor.you obtain the following data:
RGB58-A/U COAXIAL CABLE :(ohms)
BOTH -CONNECTERS(Tohms) :
BOTH TERMINATORS:(ohms)
50
What must you do to repair the network?
a.replace the 50 ohms terminator with 25 ohm termenator
b.replace RGB58-/U CABLE withRGB58-A/U CABLE
c.replace RGB58-/U CABLE withRGB62 /U CABLE
d.replace T-connecter with new ones.
ans:b
90.The users on your network compolained about the slow perfomance on the 500-network .you suspect that a networkadapter card are generating large mount of traffic.Which tool could you use to detect it:
a.tdr
b.volt-ohmeter
c.otdr
d.protocol analyzer
ans:d
上一篇文章: MCSE习题——基础知识（7） 下一篇文章: MCSE习题——基础知识 ( 5 )
相关文章: