MCSE习题——NT Server（6）
添加时间: 2007-4-8 3:43:27 作者: 微软认证参考 阅读次数:61 来源: http://www.d9soft.com
16.
You want to repair a Windows NT Server installation on a computer. You do not
have the three installation disks that you need.
How should you create the three installation disks?
A. On a Microsoft MS-DOS-based computer, run Winnt.exe from the Windows NT
Server CD-ROM.
B. On a Microsoft MS-DOS-based computer, run Setup.exe from the Windows NT
Server CD-ROM.
C. On a Microsoft MS-DOS-based computer, run Winnt32.exe from the Windows NT
Server CD-ROM.
D. On a Windows NT computer, run Winnt.exe from the Windows NT Server CD-ROM.
E. On a Windows NT computer, run Setup.exe from the Windows NT Server CD-ROM.
17.
Your network uses NWLink IPX/SPX Compatible Tranport. Half of the client
computers use the 802.3 frame type, and the other half use the 802.2 frame
type.
You are adding a Windows NT Server computer to the network. This server has
one network adapter. You want all of the existing client computers to
access this new server.
What must you do on the new server?
A. Install and configure RIP for NWLink IPX/SPX Compatible Transport.
B. Configure NWLink IPX/SPX Compatible Transport to use Auto Frame Type
Detection.
C. Configure NWLink IPX/SPX Compatible Transport to use Manual Frame Type
Detection. Add the 802.3 and 802.2 frame types.
D. Install the driver for the network driver twice, once for each frame type.
Configure each instance of the driver to support one of the required
frame types.
18.
Your Windows NT Server computer has a SCSI adapter. You install a second SCSI
adapter so that you can do disk duplexing. The new SCSI adapter does not
have its BIOS enabled.
You want to make a boot disk that will allow you to start your computer by
using the second SCSI adapter if the first one fails. Which file must you
include on the boot disk to support the second SCSI adapter?
A. Bootsect.dos
B. Ntbootdd.sys
C. Scsi.inf
D. Ntfs.sys
19.
Your network is configured as a single domain that has one PDC and two BDCs.
You want to use the current PDC as an application server.
How should you reconfigure the roles of the domain controllers in order to
optimize the computer that will run the applications?
A. Promote one of the BDCs to become the PDC.
Reconfigure the former PDC as a member server.
B. Promote one of the BDCs to become the PDC.
Reinstall the former PDC and configure it as a member server.
C. Demote the PDC to become a member server.
Reinstall an existing BDC and configure it as the PDC.
D. Domote the PDC to become a member server.
Promote one of the BDCs to become the PDC.
**20.
You want to use Network Client Administrator to install Microsoft Windows 95
on a new computer.
What must you do? (Choose three)
A. Share the Windows 95 installation files.
B. Create a Windows 95 network installation startup disk.
C. Create a Windows 95 network installation disk set.
D. Boot the new computer from the network installation startup disk.
E. Install Windows 95 from the network installation disk set.
**21.
Windows NT Server 3.51 is installed on your computer. You want to upgrade to
Windows NT Server 4.0, and you want to preserve your existing configuration
settings.
How can you perform the upgrade? (Choose all that apply.)
A. Boot from the Windows NT 4.0 Setup boot disk.
Install the Windows NT 4.0 files in the directory that contains your
Windows NT 3.51 files.
B. Boot from the Windows NT 4.0 Setup boot disk.
Install the Windows NT 4.0 files in a new Winnt40 directory.
C. Start Windows NT 3.51.
Run Winnt32.exe from the Windows NT command prompt.
Install the Windows NT 4.0 files in the directory that contains your
Windows NT 3.51 files.
D. Start Windows NT 3.51.
Run Winnt.exe from the Windows NT command prompt.
Install the Windows NT 4.0 files in the directory that contains your
Windows NT 3.51 files.
22.
You are manually configuring TCP/IP on a Windows NT Server computer. The
server will be used on a nonrouted network.
You configure the IP address. What else must you configure?
A. the default gateway
B. the DNS name server
C. the subnet mask
D. the primary WINS server
24.
You install Windows NT Server on partition C of a new computer that has
three physical disks. How can you provide fault tolerance for your Windows
NT system files?
A. Convert partition C to NTFS, and then extend the partition to the second
physical disk by creating an extended volume set.
B. Mirror partition C to the second physical disk.
C. Create a stripe set by combining partition C and the second physical disk.
D. Create a stripe set with parity by combining partition C and the other
two physical disks.
25.
You want to implement a stripe set with parity on your new Windows NT Server
computer. What is the minimum number of hard disk controllers and physical
disks required to implement a stripe set with parity?
A. one hard disk controller and two physical disks
B. one hard disk controller and three physical disks
C. two hard disk comtrollers and two physical disks
D. two hard disk controllers and three physical disks
26.
Your network has 2 NetWare 3.x servers. The network also has 30 Microsoft
MS-DOS-based computers and 20 Microsoft Windows 3.1-based computers. All of
the client computers use the NetWare Client software. You want to add a
Windows NT Server computer to the network. The client computers will require
access to a NetBIOS-based client/server application on the Windows NT Server
computer.
Which software is needed on the Windows NT Server computer to provide the
required access?
A. Client Service for NetWare
B. Gateway Service for NetWare
C. NWLink IPX/SPX Compatible Transport
D. RIP for NWLink IPX/SPX Compatible Transport
27.
Your network has 1 Windows NT Server computer, 10 Microsoft Windows 95
computers, and 5 Windows NT Workstation computers. You want to use the
Windows NT Backup program to do a nightly backup of all the files on the
Windows NT Server computer, including the registry. You want to do a weekly
backup of all workstation data files.
What is the minimum backup hardware required to perform these backups?
A. 1 tape drive attached to the Windows NT Server computer only
B. 1 tape drive attached to a Windows NT Workstation computer only
C. 1 tape drive attached to the Windows NT Server computer and 1 tape drive
attached to a Windows 95 computer
D. 1 tape drive attached to a Windows NT Workstation computer and 1 tape
drive attched t oa Windows 95 computer
28.
What is the minimum hardware required for disk duplexing?
A. one hard disk controller and two physical disks
B. one hard disk controller and three physical disks
C. two hard disk controllers and two physical disks
D. two hard disk controller and four physical disks
**29.
You are configuring a Windows NT Server computer that will store important
data. Which fault-tolerance method or methods can you use to allow recovery
in the event of a hard disk failure> (Choose all that apply.)
A. disk mirroring
B. stripe set
C. stripe set with parity
C. volume set
30.
You install a RAS server on your network. Remote users will use Windows NT
Workstation computers with Dial-up Networking to access a database. The
database is stored on a different Windows NT Server computer from the RAS
servr. You want to use data encryption to provide security for information
that is transmitted to and from the database via Dial-up Networking. Users
of other client computers, which use third-party PPP software, need access
to the RAS server to run applications other than the database. These client
computers do not support data encryption.
How can you support this configuration?
A. Configure the RAS server to require data encryption for only Windows NT
Workstation computers. Configure the server that contains the database to
require data encryption for remote users.
B. Configure the RAS server to require data encryption for specific modem
ports. Configure the Windows NT Workstation computers to dial in to modems
attached to only these ports.
C. Configure the RAS server to require data encryption for specific user
accounts.
D. Configure the RAS server to allow access for all remote users. Configure
the server that contains the database to require data encryption for remote
users.
上一篇文章: MCSE习题——NT Server（7） 下一篇文章: MCSE习题——NT Server（5）
相关文章:
相关软件: